C2941 Oldsmobile Delmont Engine Fault Code

Check Solution For C2941 Oldsmobile Delmont OBD Code :

C2941 Oldsmobile Delmont engine code seems a kind of chassis problem, we try to show one by one the meaning and the solution.
Brief explanation of the C2941 Oldsmobile Delmont code and definition of C2941 Oldsmobile Delmont is the bottom side.

C2941 Oldsmobile Delmont Meaning :

c Chassis Code
Problem is controller area network wiring bus and modules.
2 MFG - Manufacturer Specific
9 Fuel And Air Metering (Injector Circuit Malfunctions Only)
4 BBV Sensor Circuit Low Voltage
1 TFP Valve Position Switch-Drive Without Drive Ratio

MFG - Manufacturer Specific codes, which have a '1' as their second digit to indicate they are unique to a particular vehicle make or model. These special codes were deemed necessary by the vehicle manufacturers so they could provide additional diagnostic information beyond the basic list of generic OBD II codes for all kinds of faults, not just emissions-related faults.

How To Fix C2941 Oldsmobile Delmont ?

The oxygen (02) sensors on your car measure the oxygen in the exhaust to determine how rich or lean the ratio of fuel and air are in the cylinders. Optimizing this mixture means better fuel economy and fewer exhaust emissions.

C2941 Oldsmobile Delmont Code Description:

While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the C2941 code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools. When you see C2941 Oldsmobile Delmont engine fault code on your engine code reader this description will help you.

C Codes List of all Chassis codes.

Final Step: In the definitions listed below, there is a test drive recommended after you've completed any repairs to see if the condition is fixed. Before you take a test drive after a repair, always erase the C Code(s) first. This will turn the check engine light off and then you will know if the check engine light returns, you've got further diagnostics to complete.

BE CAREFUL !
This engine code information is presented for information purposes only. This is not intended as repair advice and we are not responsible for any actions you take on any vehicle.

About Us | Contact | Privacy

Copyright © 2016 - EngineFaultCode.com
All rights reserved.
Sitemap

Valid CSS!